SOLIDWORKS Plastics Professional & Premium Simulation Training Registration
Entitlement to the following course is dependent on valid training credits. If you are not a Passport Holder, or if the course is not included as part of the Passport, then a Purchase Order will be required
SOLIDWORKS Plastics Professional & Premium Simulation Training
Tuesday 25th May 2021 - 09:30 to 17:00
Plastics Professional immediately gives plastic part designers or manufactures the ability to simulate more of the injection moulding process from the initial fill up to the part being ejected. A significant amount of additional set up functions are included with this level of the software and they are all detailed in the training content.
Plastics Premium gives users the full picture and introduces simulation of the cooling channels and their performance within the tool, and also the predicted part deformation or warpage. These two new analysis capabilities are fully detailed in the closing lessons of this training course.
NOTE: This course is not part of the training passport scheme.
Plastics Professional & Premium Simulation Course Introduction and Agenda
Content in this course follows the 7 lessons presented in Plastics Standard. Plastics Standard is a prerequisite for Plastics Professional/Premium and will typically be scheduled on the day before this event.
A Fundamental knowledge of plastic materials, plastic part design and/or injection mould design will be beneficial.