SOLIDWORKS Elite Specialists

SOLIDWORKS Mould Design Registration

Entitlement to the following course is dependent on valid training credits. If you are not a Passport Holder, or if the course is not included as part of the Passport, then a Purchase Order will be required
Monday 30th April 2018 - 09:30 to 17:00
2 days
Solid Solutions Bristol Office


Mould tool design in SOLIDWORKS allows you to generate the core and cavity models based on the intended engineered part already produced.

Account for draft angles, ejector pins and parting lines in your design to check the requirements for the tooling. Understand techniques of how best to work with imported data (typical in mould design) and repair ready for the tooling design to be based around this.

Course Prerequisites

Users should have completed the SOLIDWORKS Essentials training course.

Completion of the Advanced Part and Assembly courses are also strongly encouraged.

Or complete the form to book your place
Each individual must complete their own registration with their own email address.
Oliver Washington

Your Event Organiser

Oliver Washington

If you require any event details which you cannot find here please do not hesitate to contact your event organiser using the details above, we are always happy to assist wherever possible.


Solid Solutions Bristol Office
Ten Victoria Street
Telephone:01926 333777
Fax:01926 336485

Get Directions